Juniper EX2200 Hardware Guide

show interfaces xe-
Syntax show interfaces xe-fpc/pic/port
<brief | detail | extensive | terse>
<media>
<statistics>
Release Information Command introduced in Junos OS Release 9.0 for EX Series switches.
Description Display status information about the specified 10-Gigabit Ethernet interface.
NOTE: You must have a transceiver plugged into an SFP+ or an XFP port
before information about the interface can be displayed.
NOTE: On an EX Series switch, the traffic statistics for a LAG might vary
slightly from the cumulative traffic statistics of the member interfaces of the
LAG. This difference is more likely to be seen when the traffic is bursty in
nature, and because the statistics are not fetched from the LAG and the
members in the same instant. For accurate traffic statistics for a LAG, use
the aggregated Ethernet counters.
Options xe-fpc/pic/port —Display standard information about the specified 10-Gigabit Ethernet
interface.
brief | detail | extensive | terse—(Optional) Display the specified level of output.
media—(Optional) Display media-specific information about network interfaces. For
10-Gigabit Ethernet interfaces, using the media option does not provide you with
new or additional information. The output is the same as when the media option is
not used.
statistics—(Optional) Display static interface statistics. For 10-Gigabit Ethernet interfaces,
using the statistics option does not provide you with new or additional information.
The output is the same as when the statistics option is not used.
Required Privilege
Level
view
Related
Documentation
Monitoring Interface Status and Traffic on page 233•
• Troubleshooting Network Interfaces on EX3200 Switches
• Troubleshooting Network Interfaces on EX4200 Switches
• Troubleshooting an Aggregated Ethernet Interface on page 329
• Junos OS Ethernet Interfaces Configuration Guide
307Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g