EasyManuals Logo

Juniper EX2200 Hardware Guide

Juniper EX2200
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
link-protection
Syntax link–protection {
disable;
(revertive |non-revertive);
}
Hierarchy Level [edit interfaces aex aggregated-ether-options]
[edit interfaces aex aggregated-ether-options lacp]
Release Information Statement introduced in Junos OS Release 8.3.
Statement introduced in Junos OS Release 9.0 for EX Series switches.
Support for disable, revertive, and non-revertive statements added in Junos OS Release
9.3.
Description On the router, for aggregated Ethernet interfaces only, configure link protection. In addition
to enabling link protection, a primary and a secondary (backup) link must be configured
to specify what links egress traffic should traverse. To configure primary and secondary
links on the router, include the primary and backup statements at the [edit interfaces
ge-fpc/pic/port gigether-options 802.3ad aex] hierarchy level or the [edit interfaces
fe-fpc/pic/port fastether-options 802.3ad aex] hierarchy level.
On the switch, you can configure either Junos OS link protection for aggregated Ethernet
interfaces or the LACP standards link protection for aggregated Ethernet interfaces.
For Junos OS link protection, specify link-protection at the following hierarchy levels:
[edit interfaces ge-fpc/pic/port ether-options 802.3ad aex]
[edit interfaces xe-fpc/pic/port ether-options 802.3ad aex]
For LACP standards link protection, specify link-protection at the following hierarchy
levels:
For global LACP link protection, specify at [edit chassis aggregated-devices ethernet
lacp]
For a specific aggregated Ethernet interface, specify at [edit interfaces aeX
aggregated-ether-options lacp]
Options The statements are explained separately.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
Configuring Aggregated Ethernet Link Protection on page 89
Configuring LACP Link Protection of Aggregated Ethernet Interfaces (CLI Procedure)
on page 87
Copyright © 2015, Juniper Networks, Inc.202
Network Interfaces for EX4300 Switches

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals