[edit interfaces irb] Configuration Statement Hierarchy on EX Series Switches
This topic lists supported and unsupported configuration statements in the [edit interfaces
irb] hierarchy level on EX Series switches.
•
Supported statements are those that you can use to configure some aspect of a
software feature on the switch.
•
Unsupported statements are those that appear in the command-line interface (CLI)
on the switch, but that have no effect on switch operation if you configure them.
•
Not all features are supported on all switch platforms. For detailed information about
feature support on specific EX Series switch platforms, see EX Series Switch Software
Features Overview.
This topic lists:
•
Supported Statements in the [edit interfaces irb] Hierarchy Level on page 134
•
Unsupported Statements in the [edit interfaces irb] Hierarchy Level on page 137
Supported Statements in the [edit interfaces irb] Hierarchy Level
The following hierarchy shows the [edit interfaces irb] configuration statements supported
on EX Series switches.
interfaces {
irb {
accounting-profile name;
description text;
disable;
(gratuitous-arp-reply | no-gratuitous-arp-reply);
hold-time up milliseconds down milliseconds;
mtu bytes;
no-gratuitous-arp-request;
traceoptions {
flag flag;
}
(traps | no-traps);
unit logical-unit-number {
accounting-profile name;
bandwidth rate;
description text;
disable;
family inet {
accounting {
destination-class-usage;
source-class-usage {
input;
output;
}
}
address ipv4-address {
Copyright © 2015, Juniper Networks, Inc.134
Network Interfaces for EX4300 Switches