Juniper EX2200 Hardware Guide

show forwarding-options enhanced-hash-key
Syntax show forwarding-options enhanced-hash-key
Release Information Command introduced in Junos OS Release 13.2X51-D15 for EX Series switches.
Command introduced in Junos OS Release 13.2X51-D20 for QFX Series devices.
Description Display information about which packet fields are used by the hashing algorithm to make
hashing decisions.
You can configure the fields that are inspected by the hashing algorithm to make hashing
decisions for traffic entering a LAG bundle using the forwarding-options enhanced-hash-key
statement.
Required Privilege
Level
view
Related
Documentation
Configuring the Fields in the Algorithm Used To Hash LAG Bundle and ECMP Traffic
(CLI Procedure) on page 94
•
• Understanding the Algorithm Used to Hash LAG Bundle and Egress Next-Hop ECMP
Traffic on page 11
• enhanced-hash-key on page 170
List of Sample Output show forwarding-optionsenhanced-hash-key(Layer 2 Payload Hash Mode) on page260
show forwarding-options enhanced-hash-key (Layer 2 Header Hash Mode) on page 261
Output Fields Table 46 on page 259 lists the output fields for the show forwarding-options
enhanced-hash-key command. Output fields are listed in the approximate order in which
they first appear.
Table 46: show forwarding-options enhanced-hash-key Output Fields
Field DescriptionField Name
Current hash mode: Layer 2 header or Layer 2 payload.Hash-Mode
Indicates whether the Protocol field is or is not used by the hashing algorithm: Yes or
No.
Protocol
Indicates whether the Destination L4 Port field is or is not used by the hashing
algorithm: Yes or No.
Destination L4
Port
Indicates whether the Source L4 Port field is or is not used by the hashing algorithm:
Yes or No.
Source L4 Port
Indicates whether the Destination IPv4 Addr field is or is not used by the hashing
algorithm: Yes or No.
Destination IPv4
Addr
Indicates whether the Source IPv4 Addr field is or is not used by the hashing algorithm:
Yes or No.
Source IPv4 Addr
259Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g