Juniper EX2200 - Connecting DC Power to an EX2200 Switch

unit logical-unit-number {
accounting-profile name;
arp-resp (restricted | unrestricted);
bandwidth rate;
description text;
disable;
encapsulation type;
family ccc;
filter {
group group-number;
input filter-name;
input-list [filter-names];
output filter-name;
output-list [filter-names];
}
policer {
input policer-name;
output policer-name;
}
}
family ethernet-switching {
filter {
input filter-name;
output filter-name;
}
interface-mode (access | trunk);
recovery-timeout seconds;
storm-control profile-name;
vlan {
members (vlan-name |[-vlan-names] | all);
}
}
family inet {
accounting {
destination-class-usage;
source-class-usage {
input;
output;
}
}
address ipv4-address {
arp ip-address (mac | multicast-mac) mac-address <publish>;
broadcast address;
preferred;
primary;
vrrp-group group-number {
(accept-data | no-accept-data);
advertise–interval seconds;
advertisements-threshold number;
authentication-key key;
authentication-type authentication;
fast-interval milliseconds;
(preempt | no-preempt) {
hold-time seconds;
}
priority number;
121Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements