Juniper EX2200 Hardware Guide

}
}
}
family iso family iso {
address interface-address;
mtu bytes;
}
Hierarchy Level [edit interfaces interface-name unit logical-unit-number],
[edit interfaces interface-range name unit logical-unit-number]
Release Information Statement introduced in Junos OS Release 9.0 for EX Series switches, including options
ethernet-switching, inet, and iso.
Option inet6 introduced in Junos OS Release 9.3 for EX Series switches.
Options ccc introduced in Junos OS Release 9.5 for EX Series switches.
Description Configure protocol family information for the logical interface on the switch.
You must configure a logical interface to be able to use the physical device.
Default Interfaces on EX4300 switches are set to family ethernet-switching by the default factory
configuration. Before you can change the family setting for an interface to another family
type, you must delete this default setting or any user-configured family setting.
177Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g