Juniper EX2200 - Connecting a Switch to a Network for Out-of-Band Management

}
priority-hold-time seconds;
route ip-address/mask routing-instance instance-name priority-cost cost;
}
virtual-inet6-address [addresses];
virtual-link-local-address ipv6–address;
vrrp-inherit-from {
active-group group-name;
active-interface interface-name;
}
}
}
(dad-disable | no-dad-disable);
filter {
input filter-name;
output filter-name;
}
mtu bytes;
nd6-stale-time time;
no-neighbor-learn;
no-redirects;
policer {
input policer-name;
output policer-name;
}
rpf-check {
fail-filter filter-name;
mode {
loose;
}
}
}
family iso {
address interface-address;
mtu bytes;
}
input-vlan-map action;
interface-shared-with {
psd-name;
}
output-vlan-map action;
proxy-arp (restricted | unrestricted);
swap-by-poppush;
(traps | no-traps);
vlan-id vlan-id-number;
vlan-id-list [vlan-id vlan-id–vlan-id];
}
vlan-tagging;
}
}
123Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements