Juniper EX2200 Hardware Guide

Default Autonegotiation is automatically enabled. No explicit action is taken after the
autonegotiation is complete or if the negotiation fails.
Options remote-fault (local-interface-online | local-interface-offline)—(Optional) For M Series,
MX Series, T Series, TX Matrix routers, and ACX Series routers only, manually configure
remote fault on an interface.
Default: local-interface-online
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Gigabit Ethernet Autonegotiation Overview
• Configuring J Series Services Router Switching Interfaces
• Configuring Gigabit Ethernet Interfaces (CLI Procedure)
• Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 32
Copyright © 2015, Juniper Networks, Inc.162
Network Interfaces for EX4300 Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g