Juniper EX2200 - Page 329

Table 52: show interfaces xe- Output Fields (continued)
Level of OutputField DescriptionField Name
brief
detail
extensive
none
User-configured interface description.Description
brief
detail
extensive
none
Encapsulation being used on the physical interface.Link-level type
brief
detail
extensive
none
Maximum transmission unit size on the physical interface.MTU
brief
detail
extensive
none
Speed at which the interface is running.Speed
brief
detail
extensive
none
Duplex mode of the interface.Duplex
detail
extensive
none
Not supported on EX Series switches.BPDU Error
detail
extensive
none
Not supported on EX Series switches.MAC-REWRITE
Error
brief
detail
extensive
none
Loopback status: Enabled or Disabled. If loopback is enabled, type of loopback:
Local or Remote.
Loopback
brief
detail
extensive
none
Source filtering status: Enabled or Disabled.Source filtering
brief
detail
extensive
none
Flow control status: Enabled or Disabled.Flow control
brief
detail
extensive
none
Information about the physical device.Device flags
309Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands