Juniper EX2200 Hardware Guide

•
Port Role—Enables you to assign a profile for the selected interface.
NOTE: When you select a particular port role, preconfigured port security
parameters are set for the VLAN that the interface belongs to. For
example, if you select the port role Desktop, the port security options
examine-dhcp and arp-inspection are enabled on the VLAN that the
interface belongs to. If there are interfaces in the VLAN that have static
IP addresses, those interfaces might lose connectivity because those
static IP addresses might not be present in the DHCP pool. Therefore,
when you select a port role, ensure that the corresponding port security
settings for the VLAN are applicable to the interface.
For basic information about port security features such as DHCP
snooping (CLI option examine-dhcp) or dynamic ARP inspection (DAI)
(CLI option arp-inspection), see Configuring Port Security (J-Web
Procedure). For detailed descriptions of port security features, see the
Port Security topics in the EX Series documentation at
http://www.juniper.net/techpubs/.
Click Details to view the configuration parameters for the selected port role.
•
VLAN—Enables you to configure VLAN options for the selected interface.
•
Link—Enables you to modify the following link options for the selected interface:
•
Speed
•
MTU
•
Autonegotiation
•
Flow Control
•
Duplex
•
Media Type
•
IP—Enables you to configure an IP address for the interface.
4. Configure the interface by configuring options in the selected option set. See
Table 11 on page 37 for details of the options.
5. Repeat Steps 3 and 4 for the remaining option sets that you want to configure for the
interface.
NOTE: To enable or disable the administrative status of a selected
interface, click Enable Port or Disable Port.
Copyright © 2015, Juniper Networks, Inc.36
Network Interfaces for EX4300 Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g