0.9 V 900 mV
2.5 V 2500 mV
3.3 V bias 3332 mV
11. Use the show chassis environment fpc command to to check the temperature of each
component.
NOTE: PMB, Intake, Exhaust A, Exhaust B, TLn, and TQn correspond to
temperature sensors located on the FPCs.
user@host> show chassis environment fpc
FPC 0 status:
State Online
PMB Temperature 35 degrees C / 95 degrees F
Intake Temperature 33 degrees C / 91 degrees F
Exhaust A Temperature 51 degrees C / 123 degrees F
Exhaust B Temperature 43 degrees C / 109 degrees F
TL0 Temperature 48 degrees C / 118 degrees F
TQ0 Temperature 53 degrees C / 127 degrees F
TL1 Temperature 56 degrees C / 132 degrees F
TQ1 Temperature 58 degrees C / 136 degrees F
TL2 Temperature 55 degrees C / 131 degrees F
TQ2 Temperature 57 degrees C / 134 degrees F
TL3 Temperature 59 degrees C / 138 degrees F
TQ3 Temperature 59 degrees C / 138 degrees F
Power
PMB 1.05v 1049 mV
PMB 1.5v 1500 mV
PMB 2.5v 2500 mV
PMB 3.3v 3299 mV
PFE0 1.5v 1500 mV
PFE0 1.0v 999 mV
TQ0 0.9v 900 mV
TL0 0.9v 900 mV
PFE1 1.5v 1499 mV
PFE1 1.0v 999 mV
TQ1 0.9v 899 mV
TL1 0.9v 900 mV
PFE2 1.5v 1500 mV
PFE2 1.0v 1000 mV
TQ2 0.9v 900 mV
TL2 0.9v 900 mV
PFE3 1.5v 1499 mV
PFE3 1.0v 1000 mV
TQ3 0.9v 900 mV
TL3 0.9v 900 mV
Bias 3.3v 3327 mV
FPC 3.3v 3300 mV
FPC 2.5v 2500 mV
SAM 0.9v 900 mV
A 12.0v 2014 mV
B 12.0v 2030 mV
12. Use the show chassis environment command to verify that the status of each
component is OK.
Copyright © 2012, Juniper Networks, Inc.132
PTX5000 Packet Transport Switch Hardware Guide
To Next Page
Loading...
