CAUTION: Before services gateway installation begins, a licensed electrician
must attach a cable lug to the grounding and power cables that you supply.
A cable with an incorrectly attached lug can damage the services gateway
(for example, by causing a short circuit).
To ground the services gateway:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the ESD point on the chassis. For more details, see “Preventing Electrostatic
Discharge Damage to the SRX650 Services Gateway” on page 168.
2. Ensure that all grounding surfaces are clean and brought to a bright finish before
grounding connections are made.
3. Connect the grounding cable to a proper earth ground.
4. Place the grounding cable lugs over the grounding points (sized for metric M5 x 0.8,
12 mm long grounding screws) on the side of the chassis.
5. Secure the grounding cable lugs to the grounding points, first with the washers, then
with the screws.
6. Dress the grounding cable and verify that it does not touch or block access to the
services gateway components and that it does not drape where people could trip on
it.
Related
Documentation
• Powering On the SRX650 Services Gateway on page 94
• Powering Off the SRX650 Services Gateway on page 95
• Required Tools and Parts for Grounding, Powering On, and Powering Off the SRX650
Services Gateway on page 81
• SRX650 Services Gateway General Safety Guidelines and Warnings on page 165
83Copyright © 2018, Juniper Networks, Inc.
Chapter 16: Grounding the SRX650 Services Gateway
To Next Page
Loading...
Need help?
General
