CHAPTER 10
Power Requirements and Specifications
•
SRX650 Services Gateway Electrical Wiring Guidelines on page 53
•
SRX650 Services Gateway Supported AC Power Cords on page 54
•
SRX650 Services Gateway DC Power Supply Electrical Specifications on page 56
•
SRX650 Services Gateway AC Power Supply Electrical Specifications on page 56
•
SRX650 Services Gateway DC Power Cable Specifications on page 57
•
SRX650 Services Gateway Power Requirements on page 58
SRX650 Services Gateway Electrical Wiring Guidelines
Table 13 on page 53 describes the factors you must consider while planning the electrical
wiring for the SRX650 Services Gateway at your site.
CAUTION: It is particularly important to provide a properly grounded and
shielded environment and to use electrical surge-suppression devices.
Table 13: Site Electrical Wiring Guidelines for the SRX650 Services Gateway
GuidelineSite Wiring Factor
To ensure that signaling functions optimally:
•
Install wires correctly.
Improperly installed wires can emit radio interference.
•
Do not exceed the recommended distances or pass wires between
buildings.
Thepotentialfordamagefrom lightning strikes increases if wires exceed
recommended distances or if wires pass between buildings.
•
Shield all conductors.
The electromagnetic pulse (EMP) caused by lightning can damage
unshielded conductors and destroy electronic devices.
Signaling limitations
53Copyright © 2018, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
