Juniper SRX650 - 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Physical Specifications

CHAPTER 13
Unpacking the Services Gateway
•
Required Tools and Parts for Unpacking the SRX650 Services Gateway on page 65
•
Unpacking the SRX650 Services Gateway on page 65
•
Verifying Parts Received with the SRX650 Services Gateway on page 66
Required Tools and Parts for Unpacking the SRX650 Services Gateway
To unpack the SRX650 Services Gateway, you need the following tools:
•
Phillips (+) screwdriver, number 2
•
1/2 in. (13 mm) open-end or socket wrench to remove bracket bolts from the shipping
pallet
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
Unpacking the SRX650 Services Gateway on page 65•
• Verifying Parts Received with the SRX650 Services Gateway on page 66
• Preparing the SRX650 Services Gateway for Rack-Mount Installation on page 69
• Installation Overview for the SRX650 Services Gateway on page 63
Unpacking the SRX650 Services Gateway
The SRX650 Services Gateway is shipped in a cardboard carton and secured with foam
packing material. The carton also contains an accessory box and quick start instructions.
NOTE: The services gateway is maximally protected inside the cardboard
carton. Do not unpack it until you are ready to begin installation.
65Copyright © 2018, Juniper Networks, Inc.