EasyManuals Logo

Juniper SRX650 Hardware Guide

Juniper SRX650
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
Table 30: Configuring Basic Settings
Using the CLI
Using the J-Web Setup
Wizard
Required or
OptionalTask
Navigate to the top of
the configuration
hierarchy in the CLI.
From the [edit]
hierarchy level, type:
edit system
After establishing basic
connectivity and entering root
as the default username (see
“Connecting to the SRX650
Services Gateway Setup
Wizard” on page 100), click
Enter. The J-Web setup
wizard appears. Click Start at
the bottom of the
Introduction page.
RequiredNavigate to
Configure System:
Identification page.
Specify the hostname.
For example:
set host-name devicea
On the Configure System:
Identification page, type the
hostname of the services
gateway; for example,
devicea.
RequiredDefine the
hostname of the
services gateway.
Specify the domain
name. For example:
set domain-name
lab.device.net
From the Configure System:
Identification page, type the
domain name of the services
gateway; for example,
lab.device.net.
RequiredIdentify the domain
name of the
network or
subnetwork to
which the services
gateway belongs.
Specify the root
password. For
example:
set root-authentication
ssh-rsa “ssh-rsa
AAAAB3Nza...D9Y2gXF9ac==
root@devicea.lab.device.net”
1. On the Configure System:
Identification page, type
the root password, for
example ssh-rsa
AAAAB3Nza...D9Y2gXF9ac==
root@devicea.lab.device.net
2. Retype the password in
the Verify root password
field.
RequiredDefine the root
password for the
user with
unrestricted access
to the services
gateway.
NOTE: For
readability, the
entire key is not
shown.
Set the default
gateway IP address
and the next-hop
router address. For
example:
set interfaces ge-0/0/1
unit 0 family inet
address 10.0.0.1/24
set routing-options
static route 0.0.0.0/0
next-hop 10.0.0.2
NOTE: The example
assumes that the
next-hop router
address is 10.0.0.2.
From the Configure System:
Network Settings page, type
the IP address of the default
gateway; for example,
10.0.0.1/24.
OptionalDefine the IP
address of the
default gateway.
The default
gateway is the IP
addressand subnet
of the next-hop
router, which is
generally provided
by the ISP for a
branch office.
Copyright © 2018, Juniper Networks, Inc.114
SRX650 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX650 and is the answer not in the manual?

Juniper SRX650 Specifications

General IconGeneral
BrandJuniper
ModelSRX650
CategoryGateway
LanguageEnglish

Related product manuals