Juniper SRX650 - Dual CT1 E1 GPIM; Dual CT1 E1 GPIM Overview

CHAPTER 20
Maintaining Components
•
Required Tools and Parts for Maintaining the SRX650 Services Gateway Hardware
Components on page 123
•
Routine Maintenance Procedures for the SRX650 Services Gateway on page 123
•
Maintaining the SRX650 Services Gateway Cooling System Components on page 124
•
Maintaining the SRX650 Services Gateway Power Supply on page 124
Required Tools and Parts for Maintaining the SRX650 Services Gateway Hardware
Components
The following tools and parts are required to maintain the hardware components of the
services gateway:
•
Electrostatic bag or antistatic mat
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade screw-blade screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdrivers, number 1 and number 2
Related
Documentation
Routine Maintenance Procedures for the SRX650 Services Gateway on page 123•
• Maintaining the SRX650 Services Gateway Cooling System Components on page 124
• Maintaining the SRX650 Services Gateway Power Supply on page 124
Routine Maintenance Procedures for the SRX650 Services Gateway
For optimum performance of the services gateway, perform the following preventive
maintenance procedures regularly:
•
Inspect the installation site for moisture, loose wires or cables, and excessive dust.
•
Make sure that airflow is unobstructed around the services gateway and into the air
intake vents.
•
Check the status LEDs on the front panel of the services gateway, the back panel, and
on the Services and Routing Engine (SRE) you are using.
123Copyright © 2018, Juniper Networks, Inc.