Juniper SRX650 - Packing the SRX650 Services Gateway for Shipment

•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade screwdriver, approximately 1/4 in. (6 mm)
•
Phillips (+) screwdrivers, numbers 1 and 2
Related
Documentation
Return Procedure for the SRX650 Services Gateway on page 156•
• Packing the SRX650 Services Gateway for Shipment on page 159
• Packing the SRX650 Services Gateway Components for Shipment on page 160
Packing the SRX650 Services Gateway for Shipment
To pack the SRX650 Services Gateway for shipment:
1. Retrieve the shipping carton and packing materials in which the services gateway was
originally shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
2. Attach an electrostaticdischarge (ESD) grounding strapto your bare wrist and connect
the strap to the ESD point on the chassis or to an outside ESD point if the device is
disconnected from earth ground. For more information about ESD, see “Preventing
Electrostatic Discharge Damage to the SRX650 Services Gateway” on page 168.
3. On the console or other management device connected to the services gateway, enter
the CLI operational mode and issue the following command to shut down the services
gateway software:
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
4. Shut down power to the services gateway by pressing the Power button on the front
of the services gateway.
5. Disconnect power from the services gateway.
6. Remove the cables that connect to all external devices.
7. Remove the SRE (and GPIMs, if any have been installed) from the services gateway.
8. If the services gateway is installed in a rack, have one person support the weight of
the services gateway while another person unscrews and removes the mounting
screws.
9. Place the services gateway in the shipping carton.
159Copyright © 2018, Juniper Networks, Inc.
Chapter 26: Contacting Customer Support and Returning Components