Figure 24: Removing an AC Power Supply from the SRX650 Services Gateway
Related
Documentation
Installing an AC Power Supply on the SRX650 Services Gateway on page 77•
• Required Tools and Parts for Replacing Hardware Components on the SRX650 Services
Gateway on page 141
• Disconnecting an AC Power Cord from the SRX650 Services Gateway on page 146
Disconnecting an AC Power Cord from the SRX650 Services Gateway
WARNING: Beforeworking on an AC-powered device or near powersupplies,
unplug the power cord.
To disconnect the AC power cord:
1. Unplug the power cord from the power source receptacle.
2. Attach an electrostaticdischarge (ESD) grounding strapto your bare wrist and connect
the strap to one of the ESD points on the chassis. For more information about ESD,
see “Preventing Electrostatic Discharge Damage to the SRX650 Services Gateway”
on page 168.
3. Unplug the power cord from the appliance inlet on the power supply.
Related
Documentation
Connecting an AC Power Cord to the SRX650 Services Gateway on page 92•
• Removing an AC Power Supply from the SRX650 Services Gateway on page 145
• Required Tools and Parts for Replacing Hardware Components on the SRX650 Services
Gateway on page 141
Copyright © 2018, Juniper Networks, Inc.146
SRX650 Services Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
