Juniper SRX650 - 2-Port 10-Gigabit Ethernet XPIM Hardware Specifications

CHAPTER 18
Providing Power to the SRX650 Services
Gateway
•
Connecting the SRX650 Services Gateway to the AC Power Supply on page 91
•
Connecting an AC Power Cord to the SRX650 Services Gateway on page 92
•
Connecting the SRX650 Services Gateway to the DC Power Supply on page 93
•
Powering On the SRX650 Services Gateway on page 94
•
Powering Off the SRX650 Services Gateway on page 95
Connecting the SRX650 Services Gateway to the AC Power Supply
CAUTION: Do not mix AC and DC power supplies within the same services
gateway. Damage to the device might occur.
The 645 W AC power supply with PoE support is available for the SRX650 Services
Gateway. You connect AC power to the services gateway by attaching the power cord
from the AC power source to the AC appliance inlet located on the power supply. The
power cord is not provided.
To connect the services gateway to an AC power supply:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the ESD point on the side of the chassis.
2. Locate the power cord or cords you will use to connect the services gateway to AC
power.
3. Insert the appliance coupler end of the power cord into the appliance inlet on the
power supply.
4. Insert the power cord plug into an external AC power source receptacle.
91Copyright © 2018, Juniper Networks, Inc.