EasyManuals Logo

Juniper SRX650 Hardware Guide

Juniper SRX650
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #153 background imageLoading...
Page #153 background image
Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway on page 129
Removing an AC Power Supply from the SRX650 Services Gateway on page 145
SRX650 Services Gateway Front Panel on page 18
SRX650 Services Gateway Back Panel on page 24
Using the RESET CONFIG Button on the SRX650 Services Gateway
If a configuration fails or denies management access to the services gateway, you can
use the RESET CONFIG button to restore the services gateway to the factory default
configuration or a rescue configuration. For example, if someone inadvertently commits
a configuration that denies management access to a services gateway, you can delete
the invalid configuration and replace it with a rescue configuration by pressing the RESET
CONFIG button. The button is recessed to prevent it from being pressed accidentally.
The rescue configuration is a previously committed, valid configuration. You must have
previously set the rescue configuration through the J-Web interface or the CLI.
To press the RESET CONFIG button, insert a small probe (such as a straightened paper
clip) into the pinhole on the front panel.
CAUTION:
By default, pressing and quickly releasing the RESET CONFIG button loads
and commits the rescue configuration through the J-Web interface or the
CLI. (For details, see the CLI Explorer.)
By default, pressing and holding the RESET CONFIG button for 15 seconds
or more—until the STATUS LED blinks red—deletes all configurations on
the services gateway, including the backup configurations and rescue
configuration, and loads and commits the factory configuration.
For details about factory-default settings, see “Viewing Factory-Default Settings of the
SRX650 Services Gateway” on page 106.
For details about performing initial software configuration, see “Configuring Basic Settings
for the SRX650 Services Gateway with the CLI or the J-Web Interface” on page 113.
Related
Documentation
Changing the RESET CONFIG Button Behavior on the SRX650 Services Gateway on
page 136
Troubleshooting with LEDs on the SRX650 Services Gateway on page 126
Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway on page 129
Troubleshooting the Power System on the SRX650 Services Gateway on page 132
Resetting the SRX650 Services Gateway on page 136
135Copyright © 2018, Juniper Networks, Inc.
Chapter 21: Troubleshooting Components

Table of Contents

Other manuals for Juniper SRX650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX650 and is the answer not in the manual?

Juniper SRX650 Specifications

General IconGeneral
BrandJuniper
ModelSRX650
CategoryGateway
LanguageEnglish

Related product manuals