Juniper SRX650 - DC Power Electrical Safety Guidelines

•
When a services gateway is equipped with multiple AC power supplies, all power cords
(one for each power supply) must be unplugged to completely disconnect power to
the switch.
•
Note the following warnings printed on the label next to the power supplies:
“CAUTION: THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
ALL POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.”
“ATTENTION: CET APPAREIL COMPORTE PLUS D'UN CORDON D'ALIMENTATION.
AFIN DE PRÉVENIR LES CHOCS ÉLECTRIQUES, DÉBRANCHER TOUT CORDON
D'ALIMENTATION AVANT DE FAIRE LE DÉPANNAGE.”
Power Cable Warning (Japanese)
The preceding translates as follows:
WARNING: The attached power cable is only for this product. Do not use the
cable for another product.
Related
Documentation
SRX650 Services Gateway General Safety Guidelines and Warnings on page 165•
• In Case of Electrical Accident on page 187
• General Electrical Safety Guidelines and Warnings on page 187
• SRX650 Services Gateway Power Requirements on page 58
• Grounding the SRX650 Services Gateway on page 82
DC Power Electrical Safety Guidelines
When working with DC-powered equipment, observe the following guidelines and
warnings:
•
DC Power Electrical Safety Guidelines
•
DC Power Disconnection Warning
•
DC Power Grounding Requirements and Warning
•
DC Power Wiring Sequence Warning
•
DC Power Wiring Terminations Warning
189Copyright © 2018, Juniper Networks, Inc.
Chapter 31: Electrical Safety Guidelines and Warnings