NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated external circuit breaker. We recommend that you
use a 15 A (250 VAC) minimum, or as permitted by local code.
5. Dress the power cord appropriately. Verify that the power cord does not block the air
exhaust and access to services gateway components or drape where people could
trip on it.
NOTE: The services gateway must be connected to earth ground during
normal operation. The protective earthing terminal on the side of the chassis
is provided to connect the services gateway to ground.
CAUTION: We recommend using a surge protector for the power connection.
Related
Documentation
Preventing Electrostatic Discharge Damage to the SRX650 Services Gateway on
page 168
•
• Grounding the SRX650 Services Gateway on page 82
• Organizing Interface Cables on the SRX650 Services Gateway on page 85
• SRX650 Services Gateway General Safety Guidelines and Warnings on page 165
Connecting an AC Power Cord to the SRX650 Services Gateway
To connect the AC power cord:
1. Locate a replacement power cord with the type of plug appropriate for your
geographical location.
2. Connect the power cord to the power supply.
3. Insert the power cord plug into an external AC power source receptacle.
4. Route the power cord along the cable restraint toward the left or right corner of the
chassis. If they are needed to hold the power cord in place, thread plastic cable ties,
which you must provide, through the openings on the cable restraint.
5. Verify that the power cord does not block the air exhaust and access to services
gateway components, or drape where people could trip on it. If the power supply is
correctly installed and functioning normally, the POWER LED lights steadily.
Copyright © 2018, Juniper Networks, Inc.92
SRX650 Services Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
