Juniper SRX650 - Packing the SRX650 Services Gateway Components for Shipment

10. Cover the services gateway with an ESD bag, and place the packing foam on top of
and around the device.
11. Replace the accessory box on top of the packing foam.
12. Securely tape the box closed.
13. Write the Return Materials Authorization (RMA) number on the exterior of the box to
ensure proper tracking.
Related
Documentation
Return Procedure for the SRX650 Services Gateway on page 156•
• Packing the SRX650 Services Gateway Components for Shipment on page 160
• Required Tools and Parts for Packing the SRX650 Services Gateway on page 158
Packing the SRX650 Services Gateway Components for Shipment
Follow these guidelines for packing and shipping individual components of the services
gateway:
•
When you return a component, make sure that it is adequately protected with packing
materials and packed so that the pieces are prevented from moving around inside the
carton.
•
Use the original shipping materials if they are available.
•
Place the individual component in an electrostatic bag.
•
Write the Return Materials Authorization (RMA) number on the exterior of the box to
ensure proper tracking.
CAUTION: Do not stack any of the services gateway components during
packing.
Related
Documentation
• Return Procedure for the SRX650 Services Gateway on page 156
• Packing the SRX650 Services Gateway for Shipment on page 159
• Required Tools and Parts for Packing the SRX650 Services Gateway on page 158
Copyright © 2018, Juniper Networks, Inc.160
SRX650 Services Gateway Hardware Guide