Juniper SRX650 - Figure 29: Placing a Component into an Electrostatic Bag

•
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can damage components.
•
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag. See
Figure 29 on page 169. If you are returning a component, place it into an electrostatic
bag before packing it.
Figure 29: Placing a Component into an Electrostatic Bag
Related
Documentation
• SRX650 Services Gateway Definition of Safety Warning Levels on page 163
• SRX650 Services Gateway Fire Safety Requirements and Fire Suppression Equipment
on page 171
• SRX650 Services Gateway General Safety Guidelines and Warnings on page 165
169Copyright © 2018, Juniper Networks, Inc.
Chapter 27: General Safety Guidelines and Warnings