Juniper SRX650 - 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module; 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module Overview

CHAPTER 12
Installation Overview
•
Installation Overview for the SRX650 Services Gateway on page 63
•
Required Tools and Parts for Installing the SRX650 Services Gateway on page 63
•
SRX650 Services Gateway Autoinstallation Overview on page 64
Installation Overview for the SRX650 Services Gateway
After you have prepared the site for installation and unpacked the SRX650 Services
Gateway, you are ready to install the device. It is important to proceed through the
installation process in the following order:
1. Review the safety guidelines explained in “General Electrical Safety Guidelines and
Warnings” on page 187.
2. Prepare the services gateway for installation as described in “Preparing the SRX650
Services Gateway for Rack-Mount Installation” on page 69.
3. Install the services gateway as described in “Installing the SRX650 Services Gateway
in a Rack” on page 72.
4. Connect cables to external devices.
5. Connect the grounding cable as described in “Grounding the SRX650 Services
Gateway” on page 82.
6. Power on the services gateway as described in “Powering On the SRX650 Services
Gateway” on page 94.
Required Tools and Parts for Installing the SRX650 Services Gateway
To install the services gateway, you need the following tools and parts:
•
Phillips (+) screwdriver, number 2
•
Tie wrap
63Copyright © 2018, Juniper Networks, Inc.