EasyManuals Logo

Juniper SRX650 Hardware Guide

Juniper SRX650
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
•
Evaluated to the TN power system
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
•
Do not work alone if potentiallyhazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
•
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
•
Operate the services gateway within marked electrical ratings and product usage
instructions.
•
For the services gateway and peripheral equipment to function safely and correctly,
use the cables and connectors specified for the attached peripheral equipment, and
make certain they are in good condition.
Related
Documentation
SRX650 Services Gateway General Safety Guidelines and Warnings on page 165•
• In Case of Electrical Accident on page 187
• AC Power Electrical Safety Guidelines on page 188
• DC Power Electrical Safety Guidelines on page 189
• SRX650 Services Gateway Power Requirements on page 58
• Grounding the SRX650 Services Gateway on page 82
AC Power Electrical Safety Guidelines
CAUTION: For services gateways with AC power supplies, an external surge
protective device (SPD) must be used at the AC power source.
The following electrical safety guidelines apply to AC-powered services gateways:
•
AC-powered services gateways are shipped with a three-wire electrical cord with a
grounding-type plug that fits only a grounding-type power outlet. Do not circumvent
this safety feature. Equipment grounding should comply with local and national
electrical codes.
•
You must provide an external certified circuit breaker rated minimum 15 A in the building
installation.
•
The power cord serves as the main disconnecting device. The socket outlet must be
near the switch and be easily accessible.
Copyright © 2018, Juniper Networks, Inc.188
SRX650 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX650 and is the answer not in the manual?

Juniper SRX650 Specifications

General IconGeneral
BrandJuniper
ModelSRX650
CategoryGateway
LanguageEnglish

Related product manuals