CHAPTER 17
Connecting the SRX650 Services
Gateway to External Devices
•
Required Tools and Parts for Connecting the SRX650 Services Gateway on page 85
•
Organizing Interface Cables on the SRX650 Services Gateway on page 85
•
Connecting the Modem to the Console Port on the SRX650 Services
Gateway on page 86
•
Connecting the CLI at the User End for the SRX650 Services Gateway on page 87
•
Connecting the Modem at the SRX650 Services Gateway End on page 88
Required Tools and Parts for Connecting the SRX650 Services Gateway
To connect the services gateway, you need an electrostatic discharge (ESD) grounding
wrist strap.
Related
Documentation
Connecting the SRX650 Services Gateway to the AC Power Supply on page 91•
• Connecting the SRX650 Services Gateway to the DC Power Supply on page 93
• Organizing Interface Cables on the SRX650 Services Gateway on page 85
Organizing Interface Cables on the SRX650 Services Gateway
Arrange network cables as follows to prevent them from dislodging or developing stress
points:
•
Secure cables so that they are not supporting their own weight as they hang to the
floor.
•
Place excess cable out of the way in neatly coiled loops.
•
Use fasteners to maintain the shape of cable loops.
Related
Documentation
Connecting the SRX650 Services Gateway to the AC Power Supply on page 91•
• Connecting the SRX650 Services Gateway to the DC Power Supply on page 93
85Copyright © 2018, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
