CHAPTER 19
Performing Initial Configuration
•
SRX650 Services Gateway Software Configuration Overview on page 97
•
SRX650 Services Gateway Basic Settings on page 98
•
Connecting to the SRX650 Services Gateway Setup Wizard on page 100
•
SRX650 Services Gateway Secure Web Access Overview on page 102
•
SRX650 Services Gateway Secure CLI Access Overview on page 103
•
Connecting to the SRX650 Services Gateway from the CLI Locally on page 104
•
Connecting to the SRX650 Services Gateway from the CLI Remotely on page 106
•
Viewing Factory-Default Settings of the SRX650 Services Gateway on page 106
•
Configuring Basic Settings for the SRX650 Services Gateway with the CLI or the J-Web
Interface on page 113
•
Displaying Basic Connectivity Configurations for the SRX650 Services
Gateway on page 117
•
Built-In Ethernet Ports for the SRX650 Services Gateway on page 118
SRX650 Services Gateway Software Configuration Overview
The Juniper Networks Junos operating system (Junos OS) is preinstalled on the SRX650
Services Gateway. When the services gateway is powered on, it is ready to be configured.
If you are setting up a services gateway for the first time, you can use the J-Web setup
wizard or the command-line interface (CLI) to perform the initial configuration.
If you are setting up many services gateways, autoinstallation can help automate the
configuration process. See “SRX650 Services Gateway Autoinstallation Overview” on
page 64.
Before you configure the services gateway for the first time, you should complete the
prerequisite tasks listed in Table 26 on page 98.
97Copyright © 2018, Juniper Networks, Inc.
To Next Page
Loading...
