NOTE: Forced shutdown is not supported on the SRX650 Services Gateway.
After powering off a power supply, wait at least 60 seconds before turning it back on.
After powering on a power supply, wait at least 10 seconds before turning it off.
After a power supply is turned on, it can take up to 60 seconds for status indicators—such
as the POWER LED (on the front panel of the chassis) and the show chassis command
display—to indicate that the power supply is functioning normally. Ignore error indicators
that appear during the first 60 seconds.
Related
Documentation
• Grounding the SRX650 Services Gateway on page 82
• Powering On the SRX650 Services Gateway on page 94
• Resetting the SRX650 Services Gateway on page 136
• SRX650 Services Gateway Front Panel on page 18
Copyright © 2018, Juniper Networks, Inc.96
SRX650 Services Gateway Hardware Guide
To Next Page
Loading...
