stp;
}
Related
Documentation
SRX650 Services Gateway Autoinstallation Overview on page 64•
• SRX650 Services Gateway Software Configuration Overview on page 97
• Configuring Basic Settings for the SRX650 Services Gateway with the CLI or the J-Web
Interface on page 113
Configuring Basic Settings for the SRX650 Services Gateway with the CLI or the J-Web
Interface
This topic describes how to configure basic settings foryour services gateway using either
the CLI or the J-Web setup wizard.
To configure basic settings on an SRX650 Services Gateway:
1. Identify the services gateway.
2. Connect it to the network.
3. Configure basic network settings.
In a typical network, the services gateway has the basic settings listed in
Table29 on page 113. Determine the values to set on the services gateway in your network.
Table 29: Sample Settings on the SRX650 Services Gateway
Sample ValueSRX650 Services Gateway Property
deviceaServices gateway hostname
10.0.0.1/24IP address for default gateway
10.148.2.21IP address of the NTP server used tosynchronize
system time
10.148.2.32IP address of the DNS server to which DNS
requests are sent
lab.device.net and device.netDomains to which the services gateway belongs
You can configure basic settings for the services gateway using either the J-Web setup
wizard or CLI as the configuration editor. Table 30 on page 114 summarizes the
configuration tasks for the initial setup for both required and optional settings.
113Copyright © 2018, Juniper Networks, Inc.
Chapter 19: Performing Initial Configuration
To Next Page
Loading...
Need help?
General
