CHAPTER 21
Troubleshooting Components
•
Troubleshooting with the CLI on the SRX650 Services Gateway on page 125
•
Troubleshooting with LEDs on the SRX650 Services Gateway on page 126
•
Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway on page 129
•
Troubleshooting the Power System on the SRX650 Services Gateway on page 132
•
Using the RESET CONFIG Button on the SRX650 Services Gateway on page 135
•
Changing the RESET CONFIG Button Behavior on the SRX650 Services
Gateway on page 136
•
Resetting the SRX650 Services Gateway on page 136
Troubleshooting with the CLI on the SRX650 Services Gateway
The Junos OS command-line interface (CLI) is the primary tool for controlling and
troubleshooting services gateway hardware, the Junos OS, routing protocols, and network
connectivity. The CLI commands display information from routing tables, information
specific to routing protocols, and information about network connectivity derived from
the ping and trace route utilities.
You need to enter the CLI commands on one or more external management devices
connected to the services gateway to display the information.
Related
Documentation
SRX650 Services Gateway Front Panel on page 18•
• SRX650 Services Gateway Services and Routing Engine 6 on page 11
• Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway on page 129
• Troubleshooting the Power System on the SRX650 Services Gateway on page 132
• Changing the RESET CONFIG Button Behavior on the SRX650 Services Gateway on
page 136
125Copyright © 2018, Juniper Networks, Inc.
To Next Page
Loading...
