Keysight Technologies B2961A - Page 48

2- 8 Keysight B2961A/B2962A SCPI Command Reference, Edition 6
Subsystem Command Summary
Setting Source Output and Measurement
[:SOUR[c]]:ARB:CURR:RAMP:RTIM
time
[:SOUR[c]]:ARB:VOLT:RAMP:RTIM
time
[:SOUR[c]]:ARB:CURR:RAMP:RTIM?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:RAMP:RTIM?
[DEFault|MINimum|MAXimum]
Set the ramp time of the ramp waveform
output. Waveform period must not exceed
1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
[:SOUR[c]]:ARB:CURR:RAMP:STAR[:L
EV] level
[:SOUR[c]]:ARB:VOLT:RAMP:STAR[:L
EV] level
[:SOUR[c]]:ARB:CURR:RAMP:STAR[:L
EV]?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:RAMP:STAR[:L
EV]?
[DEFault|MINimum|MAXimum]
Set the start level of the ramp waveform
output.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
[:SOUR[c]]:ARB:CURR:RAMP:STAR:TI
ME time
[:SOUR[c]]:ARB:VOLT:RAMP:STAR:TI
ME time
[:SOUR[c]]:ARB:CURR:RAMP:STAR:TI
ME?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:RAMP:STAR:TI
ME?
[DEFault|MINimum|MAXimum]
Set the start time of the ramp waveform
output. Waveform period must not exceed
1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
[:SOUR[c]]:ARB:CURR:SIN:AMPL
level
[:SOUR[c]]:ARB:VOLT:SIN:AMPL
level
[:SOUR[c]]:ARB:CURR:SIN:AMPL?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:SIN:AMPL?
[DEFault|MINimum|MAXimum]
Set the amplitude of the sinusoidal
waveform output.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
Command Summary Reset setting