Keysight Technologies B2961A - Page 53

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 13
Subsystem Command Summary
Setting Source Output and Measurement
[:SOUR[c]]:ARB:CURR:TRAP:TOP:TIM
E time
[:SOUR[c]]:ARB:VOLT:TRAP:TOP:TIM
E time
[:SOUR[c]]:ARB:CURR:TRAP:TOP:TIM
E?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:TRAP:TOP:TIM
E?
[DEFault|MINimum|MAXimum]
Set the top time of the trapezoidal
waveform output. Waveform period must
not exceed 1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
[:SOUR[c]]:ARB:CURR:TRI:END:TIME
time
[:SOUR[c]]:ARB:VOLT:TRI:END:TIME
time
[:SOUR[c]]:ARB:CURR:TRI:END:TIME
?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:TRI:END:TIME
?
[DEFault|MINimum|MAXimum]
Set the end time of the triangle waveform
output. Waveform period must not exceed
1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
[:SOUR[c]]:ARB:CURR:TRI:FTIM
time
[:SOUR[c]]:ARB:VOLT:TRI:FTIM
time
[:SOUR[c]]:ARB:CURR:TRI:FTIM?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:TRI:FTIM?
[DEFault|MINimum|MAXimum]
Set the fall time of the triangle waveform
output. Waveform period must not exceed
1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
[:SOUR[c]]:ARB:CURR:TRI:RTIM
time
[:SOUR[c]]:ARB:VOLT:TRI:RTIM
time
[:SOUR[c]]:ARB:CURR:TRI:RTIM?
[DEFault|MINimum|MAXimum]
[:SOUR[c]]:ARB:VOLT:TRI:RTIM?
[DEFault|MINimum|MAXimum]
Set the rise time of the triangle waveform
output. Waveform period must not exceed
1000 seconds.
time=MINimum|MAXimum|DEFault|0 to
1000 seconds.
0
Command Summary Reset setting