Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 15
Subsystem Command Summary
Setting Source Output and Measurement
[:SOUR[c]]:ARB:CURR:UDEF:BOST:AP
P append_list
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:AP
P append_list
Adds the trigger output status to the end
of the list set by the
[:SOUR[c]]:ARB:<CURR|VOLT>:UDE
F:BOST command, to which some data
might be appended to by this command.
Total number of data in the list must be
≤
100000.
append_list: List of the trigger output
status. Multiple data can be set to
append_list. Each data must be separated
by a comma.
[:SOUR[c]]:ARB:CURR:UDEF:BOST:PO
IN?
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:PO
IN?
Returns the number of data in the list set
by the
[:SOUR[c]]:ARB:<CURR|VOLT>:UDE
F:BOST command, to which some data
might be appended to by the
[:SOUR[c]]:ARB:<CURR|VOLT>:UDE
F:BOST:APP command.
[:SOUR[c]]:ARB:CURR:UDEF:BOST:SI
GN
output{,output}
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:SI
GN
output{,output}
[:SOUR[c]]:ARB:CURR:UDEF:BOST:SI
GN?
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:SI
GN?
Selects the trigger output for the user
defined waveform output.
output=INT1|INT2|EXT1|EXT2|
EXT3|EXT4|EXT5|EXT6|EXT7|EXT8|
EXT9|EXT10|EXT11|EXT12|EXT13|
EXT14
EXT1
[:SOUR[c]]:ARB:CURR:UDEF:BOST:ST
AT
state
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:ST
AT
state
[:SOUR[c]]:ARB:CURR:UDEF:BOST:ST
AT?
[:SOUR[c]]:ARB:VOLT:UDEF:BOST:ST
AT?
Enables or disables the trigger output for
the user defined waveform output.
state=1|ON|0|OFF
OFF
Command Summary Reset setting
To Next Page
Loading...
