Keysight Technologies B2961A - Page 57

Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 17
Subsystem Command Summary
Setting Source Output and Measurement
[:SOUR[c]]:CURR:CENT data
[:SOUR[c]]:VOLT:CENT data
[:SOUR[c]]:CURR:CENT? [DEFault|
MINimum|MAXimum]
[:SOUR[c]]:VOLT:CENT? [DEFault|
MINimum|MAXimum]
Sets the center or span value of the
current or voltage sweep output.
data=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
The center and span values can be
expressed by the following formula,
using the start and stop values set by the
[:SOUR[c]]:<CURR|VOLT>:<STAR|ST
OP> command. So the last command
setting is effective for these sweep
parameters.
center = (start + stop)/2
span = stop - start
0
[:SOUR[c]]:CURR:SPAN data
[:SOUR[c]]:VOLT:SPAN data
[:SOUR[c]]:CURR:SPAN? [DEFault|
MINimum|MAXimum]
[:SOUR[c]]:VOLT:SPAN? [DEFault|
MINimum|MAXimum]
0
[:SOUR[c]]:CURR[:LEV][:IMM][:AMP
L] level
[:SOUR[c]]:VOLT[:LEV][:IMM][:AMP
L] level
[:SOUR[c]]:CURR[:LEV][:IMM][:AMP
L]? [DEFault|MINimum|MAXimum]
[:SOUR[c]]:VOLT[:LEV][:IMM][:AMP
L]? [DEFault|MINimum|MAXimum]
Changes the output level of the specified
source channel immediately.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
[:SOUR[c]]:CURR[:LEV]:TRIG[:AMPL
] level
[:SOUR[c]]:VOLT[:LEV]:TRIG[:AMPL
] level
[:SOUR[c]]:CURR[:LEV]:TRIG[:AMPL
]? [DEFault|MINimum|MAXimum]
[:SOUR[c]]:VOLT[:LEV]:TRIG[:AMPL
]? [DEFault|MINimum|MAXimum]
Changes the output level of the specified
source channel immediately by receiving
a trigger from the trigger source set by the
:TRIG[c]<:ACQ|:TRAN[:ALL]>:SOUR
command.
level=MINimum|MAXimum|DEFault|
minimum to maximum source value, in A
or V. See
“Source Output Ranges” on
page 2-36.
0
Command Summary Reset setting