94 Keysight N9038A MXE Service Guide
Instrument Messages
Event Messages
–221 Settings
conflict;Range <0> is
turned off as total
range points > 40001
Max of Total range points is 400000. Reduce Scan Points or increase Step
Size in order to turn on that range
–221 Settings conflict;RF
Input 2 is not
available above 1GHz
If the frequency range is set above 1GHz, you cannot change to RF Input 2
–221 Settings
conflict;Scan Time &
Points do not apply
in current Step/Time
Control.
The Scan Time & Points are not available when Step/Time Control is set to
Step & Dwell
–221 Settings
conflict;Step Size &
Meas Time do not
apply in current
Step/Time Control.
The Step Size & Meas Time are not available when Step/Time Control is set to
Scan Time&Pts
Err# Message Verbose/Correction Information
To Next Page
Loading...
Need help?
General
