Keysight N9038A Service Guide

98 Keysight N9038A MXE Service Guide
Instrument Messages
Event Messages
–222 Data out of range;
Invalid list data
You tried to use a trace that has a number of sweep points that differs from the
current sweep points setting
–222 Data out of range;
Two entries already
exist at this x-axis
value.
When entering values for limit lines, you cannot have more than two Y-axis
(amplitude) values entered for a specific X-axis (frequency) value
–223 Too much data A data element (of block, expression, array type, or string type) had more data
then allowed by the command, or by the available memory
–223 Too much data; 200
spurs found.
Additional spurs
ignored.
There are too many spurs for the table (the limit is 200), and any additional
spurs that are found will be ignored
–224 Illegal parameter
value
An exact data value (from a list of the allowed values) was required, but not
found. See the specific feature description for information about the expected
parameter values
–224 Illegal parameter
value; <Value>
invalid. Fractional
values are not
allowed.
The seconds parameter of an LXI time may not contain a fractional portion. For
example 123456789.0 is valid, but 123456789.1 is not valid
–224 Illegal parameter
value; <value> out of
range.
The value does not fall within the valid range
–224 Illegal parameter
value; Exceeding the
max list length
The list parameters have a maximum allowed length. You are trying to set a
length longer than the maximum
–224 Illegal parameter
value; Gated FFT is
not available while
Sweep Type is set to
Swept
The gated FFT function is not available if you have selected the swept type of
sweep. You must select the FFT sweep type
–224 Illegal parameter
value; Gated LO is
not available while
Sweep Type is set to
FFT
The FFT sweep type moves the LO frequency in steps, so the gated LO function
is not available if you have selected FFT sweep
–224 Illegal parameter
value; Gated Video is
not available while
Sweep Type is set to
FFT
The gated video function is not available if you have selected the FFT sweep
type
Err# Message Verbose/Correction Information

Keysight N9038A Specifications

General

Brand	Keysight
Model	N9038A
Category	Measuring Instruments
Language	English