Chapter.7 MDP-621/641/640
Radar operation Operationmanual
7-18 93161022-03
When setting the power save function
If the power save function is set up while the radar is transmitting, the power save mode will be
activated 30 seconds after actual setting.
When a key is pressed during power save mode operation
A) If a key is pressed during the power save mode operation, the power save mode is terminated and
the 2-minute timer is activated.
B) If a key is pressed during Radar transmission, or alternatively during the 2 minute timer operation,
the power save mode will be terminated.
7.4.16 ON/OFF of variable range function (V RNG)
The "RANGE UP" and "RANGE DOWN" keys change the range of the radar in steps,
but this can be done in a continuously variable mode by using "V RNG".
(1) Display the soft menu (RADAR/PAGE1 (2)/R FUNC/NAV).
(2) If a soft key to "V RNG" is pushed, it becomes possible to use.
The left upper range becomes a reversing display.
(3) "V RNG" can change the range by the operation with the encoder.
To release the function
(1) When "V RNG" adjustment box is displayed, push the soft key to "V RNG".
(2) The display is turned off and the reversing display in the range on the left returns to the original.
NOTE: When "V RNG" is used, "RANGE UP" and "RANGE DOWN" key cannot be used.
7.4.17 Output of cursor positional data (TARGET)
This function outputs the latitude longitude data of the cursor position by the TLL format.
(1) Display the soft menu (RADAR/PAGE1 (2)/R FUNC/NAV).
(3) Move the cursor to the position that you want to output.
(4) Push "TARGET" key.
(5) Positional data is output.
NOTE: See section 10.6.6 (2)
V RNG 3.00
RADAR/PAGE1(2)/R FUNC/NAV
TARGET
RETURN
SLEEP
10M
GZ
RADAR
PAGE1
3.00
V RNG
To Next Page
Loading...
