Chapter 4 MDP-621/641/640
Installation Operation manual
4.8 Adjustment after installation
Before you turn the unit on, check the following points to make sure the system operates properly.
(1) Is the ship’s supply voltage and current within the rated range?
(2) Is the connection between the display and external sensor units correct?
(3) Are the cables routed and connected properly?
4.8.1 Setting up network
At the time of the installation, make sure that the network is properly set.
(1) IP Address Setting See section 10.2.9 (1)
(2) Host Name Setting See section 10.2.9 (2)
(3) Radar Source Setting See section 10.2.9 (3)
(4) Chart Source Setting See section 10.2.9 (4)
(5) Sounder Source Setting See section 10.2.9 (5)
(6) Subnet Mask Setting See section 10.2.9 (6)
(7) Gateway Address Setting See section 10.2.9 (7)
(8) Offset Port Number Setting See section 10.2.9 (8)
WARNING
When a radar antenna is connected, be sure to perform the following
adjustments and set ups before operating the system. Otherwise, the rada
picture shown may be erroneous.
4.8.2 Radar adjustments and setting up
At the time of the installation, make sure of the following adjustments and setting up and make sure
that the radar operates properly and its information on the screen is correct.
(1) TX Timing Adjust See section 10.4.6.1
(2) Heading Adjust See section 10.4.6.2
(3) Tuning Adjust See section 10.4.6.3
4-20 0093161022-06
To Next Page
Loading...
