Koden MDP-621 - Setting Navigation Alarms

MDP-1241/1240/1260/1210 Chapter 9
Operation manual
Navigation Data operation
9.2.2 Setting the alarms
Press the “ALARM” key of the soft menu (NAV/PAGE1) to set the alarm (Arrival, anchor watch, course
deviation, speed, water temperature).

NAV/PAGE1
ALARM
DATA
POS
NAV

NAV/PAGE1/ALARM
X
TE
RETURN
TEMP
SPEED
A
NCHOR
ARR AL
NAV
PAGE1
Sets the
water temp.
alarm.
Sets the
course
deviation
alarm.
Sets the
speed
alarm.
Sets the
arrival
alarm.
Sets the
anchor slip
alarm.
(1) Arrival alarm
The arrival alarm sounds (Beep!, Beep!, Beep!) when the destination or an on-route waypoint (set
alarm area) is reached during destination/route navigation.
Activate the arrival alarm by setting up the destination/route navigation and then set the ALARM
to ON.

NAV/PAGE1/ALARM
NAV
PAGE1
RETURN
ARR AL
SPEED
A
NCHOR
X
TE
TEMP

NAV/PAGE1/ALARM/ARR AL
RETURN
ALARM
ON
ARE
A
XXX
NAV
PAGE1
ALARM
OFF
0.05
AREA
Turns the arrival
alarm ON/OFF.


If the AREA key is pressed, the adjustment bo
x
is displayed and the alarm area is set with the
rotary control.
Designated area: 0〜9.99nm
Initial setting: 0.05nm





0093161202-06 9-5