Koden MDP-621 - Page 159

Chapter 9     MDP-1241/1240/1260/1210
Navigation Data operation Operation manual
(5) Water temperature alarm
The water temperature alarm sounds (Beep!, Beep!, Beep!) if the water temperature is within the
set alarm range or alternatively outside the set range.
The alarm will activate if the alarm range and mode are set and ALARM is set to ON.
In alarm range: The alarm will sound if the water temperature is within the set alarm range.
Out alarm range: The alarm will sound if the water temperature is outside the set alarm
range.
NAV/PAGE1/ALARM
ARR AL
XTE
RETURN
SPEED
ANCHOR
TEMP NAV
PAGE1

NAV/PAGE1/ALARM/TEMP
L ARE
A
XXX
RETURN
NAV H ARE
A
Y
YY
PAGE1
ALARM
ON
ALARM
OFF
Turns the wate
r
temperature
alarm ON/OFF.
MODE
IN
Changes the mode between In
alarm range and Out alarm
ran
g
e.
MODE
OUT



Press the L AREA key to set the lower end of the alarm range.
(Using the rotary control)
Press the H AREA key to set the higher end of the alarm range.
(Using the rotary control)


9-8 0093161202-06