Chapter 10MDP-621/641/640
MENU operation Operation manual
(1) Adjustment in AUTO (AUTO1/AUTO2/HARBOR) mode
(a) Select STC in the following order: MENU => Adjust => STC
(b) Select AUTO 1, AUTO 2 or HARBOR in the soft menu.
(c) When the screen appears, select an appropriate value from 1 to 16 with the control knob
(d) Press the ENTER key to exit from this mode.
Note: If you do not wish to change the setting, press the CANCEL key.
(2) Adjustment in MANUAL mode
(a) Set the manual STC to an appropriate value, 60 for example.
(b) Select STC in the following order: MENU => Adjust => STC
(c) Select MANUAL in the soft menu.
(d) When the adjustment menu appears, select an appropriate value from 1 to 16 with the rotary
control.
(e) Press the ENTER to exit from this mode.
Note: If you do not wish to change the setting, press the CANCEL key.
10-54 0093161022-06
To Next Page
Loading...
