KRONE operation terminal Gamma
100
Pos: 26.30.3 /BA/I nfo-Center/Großpacken presse/Hauptmenüs/ Hauptmenü 1 Einstell ungen/Menü 1-1 „Korr ekturwert Ballenlänge“ @ 18\mod_12379082431 21_78.doc @ 211159
8.11.1 Menu 1-1 „Correction value bale length“
Fig. 55
(On machines with electr. bale length adjustment)
Because of different properties of materials (for example straw, silage) the actual bale length
may differ from the pre-set target value. The correction value can be used to correct this
deviation.
Factory setting: 100%
Calling the menu
Main menu 1 “Settings” is displayed.
• You can select menu 1-1
with the rotary potentiometer. The symbol is shown in
reverse colours
• Press the rotary potentiometer
The display shows menu 1-1 "Correction value for bale length".
The bar display and the percentage value indicate the set correction value. The symbol
in
the upper line indicates that the displayed value is saved.
Setting and saving the correction value
If the bale is too long, reduce the correction value. If the bale is too short, increase the
correction value.
• Set the desired correction value with the rotary potentiometer. The symbol
in the top
line goes out
• Press the rotary potentiometer. The set correction value is saved and the symbol
appears in the upper line
• You can use the key
to close the menu currently displayed
The display shows menu level 1 "Settings".
• Pressing the key
twice brings up the basic screen
Pos: 26.30.4 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
To Next Page
Loading...
