Krone Big Pack 890 - Manual Mode; Basic Screen Manual Mode 1;2

KRONE operation terminal Gamma
84
Pos: 26.8.1 /BA/I nfo-Center/Großpackenpr esse/Grundbild Handbetrieb/Grundbi ld Handbetrieb 1/2 @ 18\mod_ 1237364340806_78. doc @ 209775
8.5 Manual mode
8.5.1 Basic screen manual mode 1/2
BPK41017_4
Fig. 42
Pos: 26.8.2 /BA/I nfo-Center/Großpackenpr esse/Grundbild Handbetrieb/Status zeile (I) oberste Zeile @ 18\ mod_1237364822166_78. doc @ 209825
Status line (I)
Current states of the machine (depending on how it is equipped) are shown in the top line of the display:
Alarm message is pending
Bale ejector out
Bale channel flaps open (if the P.T.O.
shaft is turning the icon is flashing)
Bale ejector in
Bale channel flap closed
Machine utilisation max. utilisation if
continuously inverted. Flashing on low
utilisation if not inverted when baling =>
check the packer feed sensor.
Bale chute top
Bale chute below
Upper blade bar or cutters are active:
cutting in operation
Blade bar below or cutters are passive:
no cutting operation
Bale(s) being set down
Pos: 26.8.3 /BA/- ----Seitenumbruch- ----- @ 0\mod_119617531122 6_0.doc @ 4165