Settings
244
Pos: 38.101.9 /BA/E instellungen/Großpac kenpresse/Knoter/ Einfachknoter Raspe/ Einstellung der Haltekraft des Garnhal ters Doppelknoter @ 47\mod_1285056343218_7 8.doc @ 455591
12.8.5.1 Setting the holding force of the twine retainer (6)
Fig. 176
The holding force has been preset ex works.
Note
The type and moisture content of baling material and its baling density as well as the tying
twine that is selected all require different settings, which have to be determined by trial and
error under actual working conditions.
To do this:
• Ensure stronger or weaker pre-tensioning of the twine retainer springs (2) with nut (3)
(approx. half a turn)
Note
The twine retainer should only clamp the twine securely enough so that it is not pulled out of the
twine retainer mechanism during the tying process. If the clamping effect is too great, it will tear
the twine into shreds. The clamping force must be set proportionately higher as the baling
density increases. The type and moisture content of the crops, and the type of tying twine being
used, will require different settings, which may need testing in operating conditions.
The spring (2) must never be pre-tensioned to block length.
Pos: 38.101.10 /BA/- ----Seitenumbruc h------ @ 0\mod_119617531 1226_0.doc @ 4165
To Next Page
Loading...
