Settings
230
Pos: 38.62 /BA/Einste llungen/Großpackenpr esse/Nadeleinst ellungen/Oberer Totpunkt der Nadeln @ 21\mod_123 9093619118_78.doc @ 228856
12.2.3 Top dead centre of the needles
To be able to check the upper dead point of the needles, turn the needle yoke up to its highest
position (dead centre point) (II). The needles (4) protrude out from the knotter. The distance "b"
between the upper edge of the drive disc (2) and the mid-point of the lower roll on the needle
point should be at least b = x mm with twine. If the setting is not correct, it should be corrected
by shortening or lengthening the needle connecting rod (3). The needles should not touch the
cleaners (6) of the tappet (2) in their highest position.
Pos: 38.63 /BA/Einste llungen/Großpackenpr esse/Nadeleinst ellungen/Oberer Totpunkt Mass b Einachkno ter und Doppelknoter @ 21\ mod_1239093730930_78. doc @ 228880
Single knotter: b = 120 - 130 mm
Double knotter: b = 105 - 115 mm
Pos: 38.64 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
