Krone Big Pack 890 - Setting the Height of the Needles on the Knotter

Settings
229
Pos: 38.58 /Überschri ften/Überschri ften 3/F-J/Höhe der Nade ln am Knoter einstellen @ 26\ mod_1245326395230_78. doc @ 260901
12.2.2 Setting the height of the needles on the knotter
Pos: 38.59 /BA/Einste llungen/Großpackenpr esse/Nadeleinst ellungen/Höhe der Nade ln am Knoter Bild Einfac hknoter und Doppelknoter @ 26\mod_1245326467168 _78.doc @ 260925
BPXC0154
3
4
5
7
a
1
b
6
1
2
3
4
5
7
a
b
6
2
2
Fig. 160
Standard knotter Double knotter
Pos: 38.60 /BA/Einste llungen/Großpackenpr esse/Nadeleinst ellungen/Höhe der Nade ln am Knoter einstelle n Text @ 21\mod_1239091936 086_78.doc @ 228832
Note
Only make adjustments with the twine threaded in!
• Trigger the tying process manually with machine at a standstill
• Turn the needle yoke on the flywheel manually upwards into working position until the
lower roll in the needle tip is located above the cleaners (6) of the tappet (2) (I)
• Tighten the flywheel brake to lock the needles (4) in this position
Note
The distance "a" from the lower edge of the needle roll to the upper edge of the cleaning disc
with twine must be between 1 and 3 mm.
If this dimension ”a” is not reached, it can be corrected by adjusting the screws (7). When the
needles enter the knotter, they should touch the knotter on the right in the driving direction.
Pos: 38.61 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165