Settings
238
Pos: 38.85 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Garnbremse @ 24\mod_124 0990038399_78.doc @ 241477
12.7 Twine brake Fehler! Textmarke nicht definiert.
Fig. 169
Single knotter Double Knotter
The twine brakes (2) are located in the twine box. The tying twine (1) is held under tension by
the adjusting screws (3). Different types of tying twine may have different friction properties. The
drawing tension of the tying strand must be checked when you start using a different type of
tying twine. It should always be set to a high enough level so that the twine tension springs do
not interfere with the swing angle. The dimension "X" is based on the tying twine selected and
must be determined in each individual case by testing in the twine strand. A pretension of the
twine strand that is too high may cause knotter errors and place too heavy a load on the
components involved.
Pos: 38.86 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Garnbremse einstel len Bild @ 24\mod_124099473 0258_78.doc @ 241576
Fig. 170
Pos: 38.87 /BA/Einste llungen/Großpackenpr esse/Bindegarn ei nfädeln/Enfachkno ter @ 20\mod_1239009990 035_78.doc @ 226947
Single knotter
Pos: 38.88 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Voreinstellung X = 30 – 35 mm @ 24\mod_1240994506555_7 8.doc @ 241501
Pre-setting X = 30 – 35 mm
Pos: 38.89 /BA/Einste llungen/Großpackenpr esse/Bindegarn ei nfädeln/Doppelkno ter @ 20\mod_1239010038 066_78.doc @ 226971
Double knotter
Pos: 38.90 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Ausführung Doppe lknoter Garnbremsen Garn s traffen @ 24\mod_1240994 624665_78.doc @ 241525
In the double knotter design, the twine brakes (1) in the twine box serve simply to keep the
twine tight.
Pos: 38.91 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Voreinstellung X = 30 – 35 mm @ 24\mod_1240994506555_7 8.doc @ 241501
Pre-setting X = 30 – 35 mm
Pos: 38.92 /BA/Einste llungen/Großpackenpr esse/Garnbre mse/Garnspannung am oberen Garnstrang (Doppelkno ter) @ 24\mod_1240995 388836_78.doc @ 241628