Maintenance
274
Pos: 42.30 /Überschri ften/Überschri ften 3/A-E/Bordhydr aulik @ 24\mod_12415183051 95_78.doc @ 245758
13.8.1 On-board hydraulic system
Pos: 42.31 /BA/W artung/Umwelt/Hinweis En tsorgen / Lagern von Öle und Ölfi lter Umwelt @ 32\mod_125 3101375171_78.doc @ 311770
ENVIRONMENT! - Disposal and storage of used lubricants and oil filters
Effect: Environmental damage
Store or dispose used oil and oil filters according to statutory provisions.
Pos: 42.32 /BA/W artung/Großpackenpressen/ Hydraulikanlage / B ordhydraulik/Bordhy draulik Öl wechseln Bi ld 890_1270_1290 @ 26\mod _1245660050365_78. doc @ 261822
Fig. 207
Pos: 42.33 /BA/W artung/Großpackenpressen/ Hydraulikanlage / B ordhydraulik/Bordhy draulik Öl wechseln @ 24\ mod_1241521519570_78. doc @ 245808
Pressure is supplied to the on-board hydraulic system of the machine through its own hydraulic
pump (1). It is connected to the main gearbox by a flange and does not require any
maintenance. The on-board hydraulic oil and the hydraulic oil filter must be replaced at least
once a year before the beginning of the season.
Note
When the hydraulic oil is replaced, the hydraulic cylinders must be retracted into the bale
channel chamber flaps.
To do this:
• Stop the machine
• Apply the flywheel brake
• Release the bale channel flaps with the comfort operation or the buttons on the machine
(make sure that the hydraulic cylinders of the bale channel flaps are completely retracted)
• Have a suitable container on hand to collect old fluid when changing the fluid
• Screw out the oil drain plug (2)
• Collect the used oil in a suitable drip pan
• Screw in the oil drain plug (2)
• Unscrew the dipstick (3) and add an appropriate amount of hydraulic fluid
• Check the oil level with the dipstick (3)
Oil quality / quantity: refer to Maintenance “Oil quantities and designations for the on-board
hydraulic system"
Pos: 42.34 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
Loading...
