Krone Big Pack 890 - Setting the Bale Length (Only for Electrical Bale Length Setting)

KRONE ISOBUS-Terminal CCI 100
149
Pos: 28.28.21 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbe trieb/Einstellen der Ballenlänge Handbetri eb Bild @ 43\mod_127529 4129859_78.doc @ 389985
Fig. 96
Pos: 28.28.22 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Grundbild Handbe trieb/Einstellen der Ballenlänge Handbetri eb @ 43\mod_1275294125312_ 78.doc @ 389960
9.3.4 Setting the bale length (only for electrical bale length setting)
Note
(BP 890;1270;1290)
The bale length can be set in the range from 100 - 270 cm (39 - 106 inches).
(BP 1290 HDP; BP 12130)
The bale length can be set in the range from 100 - 320 cm (39 - 126 inches).
Note
Adjust the bale length only during the beginning of a bale. Otherwise there could be a
transitional length.
Pos: 28.28.23 /BA/I nfo-Center/CC-I SOBUS-Terminal/CCI- BiG Pack/Scroll-Rad an wählen,springen,erhöh en bzw. verringern, speichern @ 43\mod_1275295 180531_78.doc @ 390064
• You can use the scroll wheel to select the desired selection (A) (the selection box is
highlighted in color)
• Pressing the scroll wheel allows you to jump to the selection box (the selection box is
highlighted in color)
• Turning the scroll wheel increases or reduces the value
• Pressing the scroll wheel causes the setting to be applied and returns you from the
selection box
Pos: 28.28.24 /BA/- ----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165